How to apply table top epoxy resin

Here's our five-step process to applying table top epoxy resin:

First, gather what epoxy you need.

You can use our UltraClear bar and table top epoxy for most epoxy projects.

• Make sure to order enough for a seal coat and a flood coat.
• Note: You will lose about 30% of the epoxy going over the edge to coat the sides unless you have a raised edge all the way around.

Second, apply a seal coat of table top epoxy.

• Follow the directions in the link above.
• Note: Make sure you wait four to ten hours before moving onto the next step (flood coating).

Third, pour a flood coat of table top epoxy.

Fourth, pop any air bubbles in your flood coat.

• Use a propane torch or a heat gun.
• Keep them a few inches away from the epoxy and never let the flame touch the epoxy.
• Move smoothly and consistently—don't pause or linger for more than a second to avoid damage.
• This step only takes a few minutes. Just cross back and forth over the area with heat until you've cleared the entire surface.

Fifth, allow it to cure for 72 hours.

• And that's it. Each order of our table top epoxy will come with a complete, detailed set of instructions for this process.
• If you no longer have your table top epoxy instructions, you can download a digital copy of them here.